If you open the door before the Ready indicator on the control panel lights up and the Error indica- tor goes off, the printer stops and repeats the calibration cycle. The toner cartridge is leaking. A diagonal line indicates a prohibited course of action. Blank pages One or more of the Registering The Printer Registering the Printer Mail Americas only —Fill out and send in the registration card enclosed in your shipment. If the media stacks too high, your printer may experience media jams and excessive media curl.
|Date Added:||16 March 2006|
|File Size:||18.72 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
High-capacity toner cartridge Holding both ends of the toner car- tridge, shake it side-to-side a few times to distribute the toner evenly.
Page The toner cartridge is leaking. Environmental Parameters Sound Emission Idle.
Click this radio button to display a sample of the page layout in the figure area. Always close the printer doors gently.
Page Margins Color printing starts 0. You remove transparencies from the output tray immediately to avoid static buildup. If it is difficult to remove printfr jammed Remove the toner cartridge and check for damage. Interface Required Connector Type.
Never expose the printer to vibrations. Best headphone deals for Christmas: One or more of the toner cartridges are defective. If you open the door before the Ready indicator on the control panel lights up and the Error indicator goes off, the printer stops and repeats qmw calibration cycle.
Anything printed in these layered regions may be lost or faded. Touching the transfer belt may result in poor print quality.
Konica Minolta magicolor W – printer – color – laser Overview – CNET
Output Tray All media is output to the output tray on top of the printer. In addition, it displays the current status of the printer, including any condition that needs your attention. The drum is also magicolog sensitive to hand oils and scratches, both of which reduce print quality.
Special Media OPC drum cartridge. Lateral lines The printer is not on a or bands level enough surface. Fuser Jams Fuser Jams Lift up the two fuser unit levers.
Page 71 Do not tilt, lubricate, or magucolor the printer. The use of non-shielded cable is likely to result in interference with radio communications, and is prohibited under EU directives.
Page 90 If the flaps are on the short edge, set printeer envelopes in Tray 1 so that the flaps are on the printer side.
When magicolro condition associated with a displayed message has changed, the message is cleared from the Status Display message window. Requirements Allow enough space around the printer to allow adequate ventilation and easy servicing.
Open the right-side door, then close it. Attach the support wire for the duplex option to the printer. And can we talk mail-order mattresses?
Minolta-QMS MagiColor W – PC World Australia
Close jagicolor right-side door securely. Close the right-side door. If you click the X button in the upper-right corner of the Status Display window to close the window, the Status Display remains available at the right end of the taskbar. Other Media Place the envelope stack into Tray 1 with the flap-side underneath. Service Messages A service message sometimes occurs as a result of an unusual combination of prinrer, not because of an actual problem.
Labels Check your application documentation for other information on printing labels. This releases the pressure on the transfer belt unit.